Цитата(benefaktor @ 6.9.2021, 15:53)
Оно ультрапастеризованное. Его нагревали больше чем на 90 градусов. Из такого не получится. Сыр делается из цельного. И пастеризуется прямо перед приготовлением на 65 град. Максимум 68
По ссылке выше:
Pasteurization
70-72 °C/15-20 s (not always employed)
Там же про цельность молока:
Fat standardization
Standardization of fat can be accomplished either by in-line remixing after the separator (see Chapter 6.2, Automatic in-line standardization systems), or, for example, by mixing whole milk and skim milk in tanks followed by pasteurization. The fat content must finally be adjusted to the protein content (or even better to the Casein content) in order to achieve the desired fat in dry solids ratio.
Protein standardization
The protein level of the milk can be adjusted by membrane filtration techniques or by adding skim milk powder. The protein content can be levelled up to a constant value corresponding to the maximum level of the year.
When the protein content is increased by ultrafiltration, the level of total dry solids in the milk increases. This affects the cheesemaking process, and ultimately the quality of the cheese. It is also possible to standardize the casein fraction, not just the total protein content.
Additives in cheese milk
The essential additives in the cheesemaking process are the starter culture and the rennet. Under certain conditions it may also be necessary to supply other components such as calcium chloride (CaCl2) and saltpetre (KNO3 or NaNO3). An enzyme, Lysozyme, has also been introduced as a substitute for saltpetre to inhibit Clostridia organisms.